高性能MS密封膠的隱框玻璃幕墻
2024-10-25
推薦新聞
玻璃幕墻使用的丁基防水嵌縫膠
2024-10-25
玻璃幕墻就對硅烷改性聚氨酯密封膠提出更高...
2024-10-25
硅烷改性聚氨酯密封膠黏度測定方法
2024-10-24
裝配式建筑外墻接縫用改性丁基防水嵌縫膠
2024-10-24
幕墻用硅酮結構MS密封膠老化后強度的要求
- 發布時間 : 2024-5-10 11:23:20
- Views:
(Summary description)Customized SILICONE STRUCTURAL SEALANT from China manufacturer refers to the adhesive with high strength, can bear large load, aging resistance, fatigue resistance and corrosion resistance, and has stable performance within the expected life. It is suitable for bearing the bonding of strong structural parts. Non structural adhesive has low strength and poor durability. It can only be used for bonding, sealing and fixing of ordinary and temporary properties, and cannot be used for structural adhesive bonding. NEUTRAL SILICONE WETHERPROOF SEALANT from China manufacturer is a structural adhesive with waterproof function. Silicone glue refers to the adhesive based on silicone rubber. According to different functions, it can be divided into structural adhesive, potting adhesive, sealant, thermal conductive adhesive, flame retardant adhesive and so on.
幕墻用硅酮結構MS密封膠老化后強度的要求
(Summary description)Customized SILICONE STRUCTURAL SEALANT from China manufacturer refers to the adhesive with high strength, can bear large load, aging resistance, fatigue resistance and corrosion resistance, and has stable performance within the expected life. It is suitable for bearing the bonding of strong structural parts. Non structural adhesive has low strength and poor durability. It can only be used for bonding, sealing and fixing of ordinary and temporary properties, and cannot be used for structural adhesive bonding. NEUTRAL SILICONE WETHERPROOF SEALANT from China manufacturer is a structural adhesive with waterproof function. Silicone glue refers to the adhesive based on silicone rubber. According to different functions, it can be divided into structural adhesive, potting adhesive, sealant, thermal conductive adhesive, flame retardant adhesive and so on.
- 發布時間 : 2024-5-10 11:23:20
- Views:
Information
老化試驗參照標準ASTM的規定進行，每12h為一個試驗循環周期，包括紫外線輻照8h，其中黑板溫度為(6013)℃;冷凝水4h，其中黑板溫度為(50士3)℃。老化時間分別為300 h,1 000 h,3 000 h,4 000 h和5 000 h，每一編號MS密封膠樣品各取出1組試件進行試驗。
拉伸粘結性試驗按照GB 16776-2005的規定進行，測量每個試樣的長寬高，以5 mm/min的速度將試樣拉伸至破壞，得到最大粘結強度和最大粘結強度時的伸長率(取5個試樣的平均值)。
粘結拉伸強度變化
4種單組分硅酮結構MS密封膠試樣的最大粘結強度隨老化時間的變化趨勢見如圖2所示，4種單組分硅酮結構MS密封膠試樣經5 000 h人工加速老化試驗后，粘結強度均)0.45MPa，滿足標準GB 16776-2005對幕墻用硅酮結構MS密封膠老化后強度的要求。1",30,5",7MS密封膠老化后的粘結強度值較初始值分別下降了約28% ,30% ,22% , 32%，其中1",3"試樣粘結強度隨老化時間延長呈線性下降，而5#,7試樣在老化初期粘結強度下降較快，3 000 h后粘結強度趨于平緩。隨老化時間的延長，4種單組分硅酮結構MS密封膠粘結強度變化規律稍有不同，但都呈下降趨勢。http://www.caffertyclinic.com/
Scan the QR code to read on your phone
+86-
13573398725
sdyuantai@163.com
